The primary issue was declaring int prod within the while loop, which caused prod to reset to 1 each time the loop executed.
There is a safety concern if the vehicle experiences a malfunction or encounters a red light or police; just operate your own vehicle instead.
num_cents = 109 if num_cents >= 100: print('Dollar or more') else: print('not a dollar')
Answer:
count = 0
while count!= 8:
height = float(input("Enter the height of the rider: "))
if height >= 140:
print("You may ride")
count += 1
else:
if height >= 120:
answer = input("Is the rider accompanied by an adult (yes/no): ")
if answer == "yes":
print("You may ride")
count += 1
else:
print("You are not permitted to ride")
else:
print("You are not permitted to ride")
Explanation:
Begin with a count of zero, which will track the number of riders allowed. Use a while loop that continues until the count reaches 8. During each iteration, request the user's height. If the height is 140 cm or taller, display "You may ride" and increment the count. If the height is 120 cm or more, check if the rider is with an adult. If not, show the message "You are not permitted to ride"; otherwise, allow the ride and increase the count. If the height is below 120 cm, deny the ride.
Answer:
subnets=65536
Explanation:
As per our knowledge,
--> the address's interface ID portion begins at 64
--> there exists a 48 bit network prefix
therefore,
the bits available for subnets are = 64-48= 16
thus, by utilizing 16 bits, the number of subnets can be calculated as = 2^16 = 65535
