Irene was investigating the behavior of gases at certain conditions. Which would most likely cause an increase in the rate of co

Answer:

ΔL = MmRgt / (2m + M)

Explanation:

The system starts from rest, so the change in angular momentum correlates directly to its final angular momentum.

ΔL = L − L₀

ΔL = Iω − 0

ΔL = ½ MR²ω

To determine the angular velocity ω, begin by drawing a free body diagram for both the pulley and the block.

For the block, two forces act: the weight force mg downward and tension force T upward.

For the pulley, three forces are present: weight force Mg down, a reaction force up, and tension force T downward.

For the sum of forces in the -y direction on the block:

∑F = ma

mg − T = ma

T = mg − ma

For the sum of torques on the pulley:

∑τ = Iα

TR = (½ MR²) (a/R)

T = ½ Ma

Substituting gives:

mg − ma = ½ Ma

2mg − 2ma = Ma

2mg = (2m + M) a

a = 2mg / (2m + M)

The angular acceleration of the pulley is:

αR = 2mg / (2m + M)

α = 2mg / (R (2m + M))

Finally, the angular velocity after time t is:

ω = αt + ω₀

ω = 2mg / (R (2m + M)) t + 0

ω = 2mgt / (R (2m + M))

Substituting into the previous equations gives:

ΔL = ½ MR² × 2mgt / (R (2m + M))

ΔL = MmRgt / (2m + M)